21
4 Clean all oil, grease or dirt from the receiver top and from the
scope base parts.
5 Remove all four filler screws from the top of the receiver using
a very small, thin-bladed gunsmithing-type screwdriver.
6 Pre-position the bases on the receiver top to determine the best
orientation of the bases.
7 Insert the screws through the bases and screw them into the
receiver top using the correct tool.
You must use screws of the appropriate length to ensure proper
thread engagement. Once the bases are installed, check inside the
receiver to verify that the base mounting screws are not too long
and interfering with the operation of the bolt.
Many gunsmiths find it helpful to use a drop of serviceable thread
locking compound to assure the screws stay tight. Make sure the
thread locking compound does not get into the action.
Be careful to assure that the threads of each screw engage
properly in the receiver threads to prevent stripping the threads
in the receiver.
8 Tighten the screws snugly, but do not overtighten.
9 Mount your scope rings and scope as outlined in the instructions
supplied with your scope rings and/or scope. Always make sure
you have the proper eye relief.
TRIGGER ADJUSTMENT
Before adjusting the trigger, always Place the “safety” in the
on safe Position. KeeP the muZZle Pointed in a safe direction
and your fingers away from the trigger. failure to follow
these warnings could result in serious injury or death.
always insPect the chamBer, Barrel and magaZine carefully
after unloading to Be sure all live cartridges are cleared
from the firearm.
To Next Page
Loading...