Need help?Do you have a question about the BRP Evinrude E-TEC G2 200 HP and is the answer not in the manual?
General| Horsepower | 200 HP |
|---|---|
| Starting | Electric |
| Gear Ratio | 1.85:1 |
| Fuel Type | Gasoline |
| Full Throttle RPM Range | 5000 - 6000 RPM |
| Engine Stroke | 2-Stroke |
| Fuel Induction System | Direct Injection |
| Shaft Length | 20 inches / 25 inches |
| Steering | Hydraulic |
| Exhaust | Through Prop |
| Cooling System | Water-cooled |
| Lubrication System | Oil Injection |
| Weight | 537 lbs (244 kg) |
Essential safety warnings and guidelines for handling the outboard and performing work.
Recommendations and procedures for safe and proper battery installation.
Steps for preparing the boat's transom for outboard mounting.
Procedures for accurate transom measurements and hole drilling.
Instructions for correct outboard mounting height and bolt installation.
Recommended fuel types, octane ratings, and additives.
Recommended lubricants and oil system priming.
Pre-operation checks including fluid levels and lubricants.
Alignment and calibration procedures for multi-engine setups.
Guidance on selecting and installing the correct propeller.
Verifying proper function of engine systems and controls.
Testing boat performance and making final adjustments.
To Next Page