Need help?Do you have a question about the BRP Evinrude E-TEC G2 250 HP and is the answer not in the manual?
General| Horsepower | 250 HP |
|---|---|
| Displacement | 3.4 L |
| Fuel System | Direct Injection |
| Gear Ratio | 1.85:1 |
| Starting System | Electric |
| Fuel Type | Gasoline |
| Cylinders | V6 |
| Full Throttle RPM Range | 5400-6000 RPM |
| Warranty | 5 Years |
| Steering | Power Steering |
| Shaft Length | 20, 25, 30 inches |
Explains safety alert signal words and general safety precautions.
Covers mechanical and hydraulic steering systems, helm compatibility, and improvements.
Provides guidance on battery recommendations, location, and connections.
Details regulations, tank types, hoses, and filters for fuel systems.
Details the correct sequence and safety precautions for connecting batteries.
Covers transom requirements, clearances, and water flow considerations.
Details how to measure and drill the transom for outboard mounting.
Provides instructions for safely removing shipping covers and lifting the outboard.
Covers outboard mounting height, bolt installation, and transom locations.
Details the procedure and safety precautions for lifting the outboard using a fixture.
Guides on setting the initial mounting height for optimal boat performance.
Specifies using marine sealant and proper torque for mounting bolts.
Covers requirements, length, and installation options for rigging hoses.
Guides on routing and connecting various cables, hoses, and wires to the rigging center.
Provides a step-by-step procedure for filling and bleeding the hydraulic steering system.
Recommends approved hydraulic fluids and warns against non-approved types.
Provides detailed instructions for filling and bleeding the system for single engine setups.
Details fuel recommendations, additives, and usage guidelines.
Explains the procedure for priming the fuel system using the electric fuel lift pump.
Specifies recommended outboard oils and procedures for filling oil tanks.
Recommends unleaded gasoline with specific AKI or RON octane ratings.
Covers checks for gearcase lubricant, 2-stroke engine oil, and trim/tilt fluid levels.
Details outboard alignment procedures and confirmation steps.
Guides propeller selection and hardware installation, including warnings.
Outlines pre-start checks for safety features, controls, displays, and engine monitoring.
Covers essential checks and adjustments performed during a water test.
Explains the importance of dual outboard alignment for water flow and performance.
Guides propeller selection based on water testing, engine RPM, and boat application.
Explains how to check the start-in-gear prevention feature for safety.
Verifies the proper function of the emergency stop switch and lanyard.
Details adjusting mounting height for optimal engine RPM, acceleration, and speed.
Provides detailed hose routing diagrams for different hydraulic steering configurations.
Diagram for hydraulic steering with two outboards, one DPS and one non-DPS.
Diagram for two stations, two outboards, one DPS and one non-DPS.
Diagram for one station, three outboards, two DPS and one non-DPS.
Diagram for two stations, three outboards, two DPS and one non-DPS.
Diagram for one station, four outboards, two DPS and two non-DPS.
Diagram for two stations, four outboards, two DPS and two non-DPS.
To Next Page