BRP Evinrude E-TEC G2 - Inspection Table

53
IInnssppeeccttiioonn TTaabbllee
Routine inspection and maintenance is necessary to ensure outboard life. The
following chart provides guidelines for inspection and maintenance. The 500
hour/5 year service should be performed by an authorized Dealer, repair shop, or
person of your own choosing.
IIMMPPOORRTTAANNTT:: Adjust the maintenance schedule for operating and environmen-
tal conditions. Outboards used in rental, commercial, or other high hour applica-
tions require more frequent inspections and maintenance.
DDeessccrriippttiioonn
DDeeaalleerr MMaaiinntteennaannccee EEvveerryy 550000 HHoouurrss oorr 55 YYeeaarrss
CCuussttoommeerr IInnssppeeccttiioonn EEvveerryy 110000 HHoouurrss oorr
AAnnnnuuaallllyy
EEnnggiinnee CCaarree PPrroodduuccttss
AAccttiioonn
Anodes (corrosion
protection)
Check condition
(1), (2)
X X
Covers Wash X
Fluid Levels (steering
and trim)
Inspect level
X
Fuel filters
Replace
X
Gearcase lubricant
Inspect level, See
GEARCASE LUBRICANT
LEVEL
.
X
Gearcase lubricant
Replace
A X
Grease fittings Lubricate
B X
Oil Filter (optional
remote oil tank only)
Replace
X
Propeller shaft splines Inspect and lubricate
B X
Service codes
Access EMM, check for and
resolve any codes
X
Spark plugs Replace
(3)
X
Thermostat
Inspect
(3)
X
Water pump Replace
X
(1) Whichever comes first. Certain conditions may require more frequent inspection and maintenance.
(2) Annually in salt water applications.
(3) Emission-related component.
INSPECTION SCHEDULE