BRP Evinrude E-TEC User Manual

22
 USING YOUR EVINRUDE E-TEC OUTBOARD
Single Lever ICON Control
1. Handle – shift and throttle
2. Trim/tilt switch
3. Fast idle (neutral) button
4. RPM Tune button
5. Gear position indicators
Dual Lever ICON Control
1. Handle – shift and throttle
2. Master Trim/tilt switch
3. Individual engine trim switches
4. Fast idle (neutral) button
5. PowerSync button
6. RPM Tune button
7. Gear position indicators
If the following directions are not suitable for your boat’s
control, see your Dealer before proceeding.
Shifting — ICON Controls
With engine running and control handle in NEUTRAL:
Move the control handle fore or aft until it engages the for-
ward or reverse gear detent.
Speed Control — ICON Controls
After gear engagement, move the control handle slowly in
the same direction to increase speed.
Press the RPM + or – button to fine tune engine speed up
or down in 1% increments.
Engine Synchronization — ICON Controls
Press the SYNC button to automatically synchronize the
RPM of multiple engines. The SYNC button also transfers
control of all engines to the port lever on the control.
3
2
4
1
5
1
2
3
4
1
5
6
7

BRP Evinrude E-TEC Specifications

General

Brand	BRP
Model	Evinrude E-TEC
Category	Outboard Motor
Language	English