Need help?Do you have a question about the BRP Evinrude E-Tec E150DPLSUF and is the answer not in the manual?
General| Model | E150DPLSUF |
|---|---|
| Horsepower | 150 hp |
| Starting | Electric |
| Fuel Type | Gasoline |
| Steering | Remote |
| Oil Injection | Yes |
| Recommended Fuel | 87 Octane |
| Warranty | 5 years |
| Full Throttle RPM Range | 5000-6000 RPM |
| Fuel Induction | Direct Injection |
| Alternator Output | 50 Amps |
| Shaft Length | 20 in |
Indicates an imminently hazardous situation that WILL result in death or serious injury if not avoided.
Indicates a potentially hazardous situation that CAN result in severe injury or death if not avoided.
Provides detailed technical specifications for engine, fuel, and electrical systems.
Procedures for hull preparation, transom mounting, and rigging the outboard.
Provides a schedule for routine inspections and maintenance tasks.
Overview of EMM functions, connections, and components.
Details internal and external sensors and their functions.
Information on LED indicators, diagnostic software, and fault codes.
Explanation of SystemCheck gauges, self-test, and running mode indicators.
Details EMM LED indicators, diagnostic software, and program information.
General troubleshooting steps and specialized test procedures.
Tests related to fuel delivery and fuel injector operation.
Analysis of ignition system output and electrical circuits.
Tests for ignition coils, stator, and the charging system.
Procedures for adjusting ignition timing and calibrating the TPS.
Tests for fuel injectors, fuel supply, and pressure.
Procedures for servicing fuel filters, lift pump, and vapor separator.
Procedures for priming the oil distribution manifold.
Tests for oil injection pump, pressure sensor, and vacuum.
Procedures for servicing oil distribution hoses and injection pump.
Methods for checking engine temperature using software or pyrometer.
Steps for removing and disassembling the powerhead components.
Procedures for cleaning internal components and inspecting parts.
Steps for assembling bearings, crankshaft, pistons, and cylinder head.
Procedures for performing leak tests and removing/installing the gearcase.
Procedures for gearcase disassembly and inspection of components.
Steps for removing and installing bearings and seals in the gearcase.
Step-by-step guide for assembling the gearcase components.
Diagnosing and resolving issues with the trim/tilt system.
Lists EMM circuit/sensor fault codes, activation conditions, and procedures.
To Next Page