278
6. Remove the spark plugs and spray storage oil for 5 seconds in
each cylinder.
7. Spin the drive pulley for three complete revolutions by hand to dis-
tribute the storage oil to coat the cylinder walls.
8. Reinstall the spark plugs and tighten to specification.
TTiigghhtteenniinngg ttoorrqquuee
Spark plug 28 ± 2 Nm (21 ± 1 lbf-ft)
EE--TTEECC EEnnggiinnee -- 44..55”” aanndd 77..22”” DDiiggiittaall DDiissppllaayy
Follow these simple steps.
To engage the procedure, do the following:
1. Place the vehicle in a well ventilated area.
2. Start the engine and let it run at idle speed until it reaches its oper-
ating temperature (watch the coolant temperature on the display or
verify the rear heat exchanger becomes warm).
3. Push the SET (S) button to select odometer mode.
STORAGE
To Next Page