Why does Bruno CURB-SIDER VSL-6000G Lifting Systems lift belt go down when UP switch is pressed?
This issue occurs when the lift has been run down too far, causing the belt to wrap backwards around the spool. To resolve this, run the lift down until the belt wraps correctly onto the spool.
General| Power Source | Vehicle Battery |
|---|---|
| Weight Capacity | 600 lbs |
| Applications | Scooter |
| Load Capacity | 600 lbs |
| Lifting Height | 36 inches |
Before loading a mobility device onto the Curb-Sider, ensure the required docking device is mounted.
Details using the control pendant to raise and swing out the lift arm.
Guides attaching the C-arm/pickup claw to the docking device and lifting the mobility device.
Explains swinging the mobility device into the vehicle and lowering it to the floor.
Instructs to secure the mobility device, set parking brake, and store the pendant safely.
Details preparing the vehicle and lift for unloading the mobility device.
Explains lifting the device from the floor and swinging it out of the vehicle.
Covers unhooking the device, swinging the lift back, and securing the pendant.
Describes extending the lift arm and rotating it to position for lifting.
Covers lowering the pick-up device, attaching it, and lifting the mobility device.
Details retracting the lift arm and lowering the device to the floor.
Ensures proper positioning, securing the device, and closing the vehicle door.
Provides instructions on how to fold down the lift head using quick release pins.
Explains how to access and use the hand crank for power failure situations.
Details how to slide the cover to access the motor and locate the emergency crank.
Covers placing and using the crank, storing it, and seeking dealer inspection.
To Next Page
