Brunswick GS Series - User Manual

To Next Page

GS-X v.III Guarding Safety Controller

Hold-to-Run Switch

Packaging

1 ea. 47-142117-000 Pkg. Hold-to-Run Cable Assembly

*1 ea. 47-142118-000 Pkg. Hold-to-Run Switch

1 ea. 47-902601-000 Installation Instructions

* One per Center Item

Tools Required

 - Straight(at)ScrewDriver

 - Phillips(cross)ScrewDriver

Hold-to-Run Cable Assembly 47-142117-000

TheHold-to-RuncableassemblyprovidesaconnectionontheSafetyControllerfortheHold-to-Run

switch.AcablemustbewiredintoeachsafetycontrollerwhereaHold-to-Runoperationisdesired.Re-

fertoFigure 1.

Figure 1

September 2012

47-902601-000

©BrunswickBowling&BilliardsCorp.2012.Allrightsreserved.

Need help?

Do you have a question about the Brunswick GS Series and is the answer not in the manual?

Summary

Hold-to-Run Cable Assembly Description

Cable Wiring and Connections

Details the wiring diagram for the cable assembly and notes on wire interchangeability.

Hold-to-Run Cable Installation

Power Off and Cover Removal

Instructions for safely shutting down the controller and preparing it for cable installation.

Cable Assembly Installation Step

Securing the Cable Assembly

Describes the process of installing the cable assembly into the safety controller using screws.

Cable Wiring Procedure

Connecting Wires to Controller

Details the wiring connections from the cable assembly to the safety controller based on diagrams.

Hold-to-Run Switch Description

Switch Operation Modes

Explains the three positions of the Hold-to-Run switch and their effect on pinsetter operation.

Functional Test of Hold-to-Run Switch

Test Procedure for Safety and Operation

Details the steps to test the switch's safety features, interlocks, and operational modes.