Technical data
and startup
6.1 Technical data .......................................................................................................................... 24
6.2 Type plate ................................................................................................................................ 26
6.3 Device warnings ....................................................................................................................... 27
6.4 Basic function ........................................................................................................................... 27
6.5 Covers ...................................................................................................................................... 28
6.6 Assembly information ............................................................................................................... 29
6.6.1 Installation position ............................................................................................................ 29
6.6.2 Fixing (as in example DMC524) ........................................................................................ 29
6.7 Example of use ........................................................................................................................ 30
6.8 Input and output values ............................................................................................................ 31
6.9 Block diagram output stage / power print .................................................................................. 32
6.10 Operating modes of the inverter ............................................................................................... 33
6.11 Regulatory approach and limitations ........................................................................................ 34
6.12 Error and warning messages .................................................................................................... 34
6.12.1 Error definition ................................................................................................................... 35
6.12.2 Warning message definition .............................................................................................. 35
7 Level of inverter efficiency ............................................................................................... 36
7.1 DMC514 measured with HSM1-10.18.04 at 400V (first quadrant) ............................................ 36
7.2 DMC524 measured with HSM1-6.17.12 at 400V (first quadrant) .............................................. 36
7.3 DMC534 measured with HSM1-10.18.13 at 400V (first quadrant) ............................................ 37
7.4 DMC544 measured with HSM1-10.18.13-W7 at 400V (first quadrant) ...................................... 37
8 Connections ....................................................................................................................... 38
8.1 Circuit connections ................................................................................................................... 38
8.2 Pin assignment motor sensor connection (device side) ............................................................ 39
8.3 Pin assignment of control connector (device side) .................................................................... 40
8.3.1 Pin 1 GND (ground terminal 31) ........................................................................................ 41
8.3.2 Pin 2 AUX (Wiring system terminal 30) .............................................................................. 41
8.3.3 Pin 3 EN (Enable, Power ON) ........................................................................................... 42
8.3.4 Pin 8 PG1, 14 PG2, 15 PG3 (Reserve ground, RS232 ground) ......................................... 42
8.3.5 Pin 11 TXD, Pin 12 RXD (RS232 interface) ....................................................................... 43
8.3.6 Pin 13 PRO (Enable firmware programming)..................................................................... 44
8.3.7 Pin 17 EXT AW1, Pin 18 EXT AW2 (External shut down path 1 + 2) ................................. 45
8.3.8 Pin 19 IL1, Pin 20 IL2 (Interlock 1 + 2) .............................................................................. 46
To Next Page
Loading...
