Bryant 619PEQ012BBMA User Manual

619PB
High Wall Ductless System
Sizes 09 to 36
Installation Instructions
NOTES:
Read the entire instruction manual before starting the
installation.
Images are for illustration purposes only. Actual models
may differ slightly.
TABLE OF CONTENTS
PAGE
SAFETY CONSIDERATIONS 2.........................
PARTS LIST 3.......................................
SYSTEM REQUIREMENTS 4...........................
WIRING 4...........................................
DIMENSIONS 5......................................
CLEARANCES 9.....................................
INSTALLATION TIPS 10...............................
INDOOR UNIT INSTALLATION 10......................
ELECTRICAL DATA 11...............................
CONNECTION DIAGRAMS 11.........................
FINAL TUBING CHECK 11............................
WIRELESS REMOTE CONTROL INSTALLATION 13......
WIRED REMOTE CONTROL INSTALLATION 13..........
START−UP 13........................................
TROUBLESHOOTING 14..............................

Bryant 619PEQ012BBMA Specifications

General

SEER Rating	Up to 19
Refrigerant	R-410A
Voltage	208/230V
Refrigerant Type	R-410A
Phase	1
Cooling Capacity	12, 000 BTU/hr
Line Set Connection Size (Liquid/Vapor)	3/8" x 5/8"

Summary

Safety Considerations

Electrical and Explosion Hazards

Warnings for electrical shock and explosion risks during installation and servicing.

Equipment Damage Cautions

System Requirements

Piping Requirements

Wiring Requirements

Clearances

Installation Clearances

Installation Tips

Indoor Unit Location Selection

Criteria for selecting an ideal installation location for the indoor unit.

Mounting Plate Installation

Wall Hole and Piping Routing

Guidance on drilling wall holes and routing refrigerant lines, drain, and wiring.

Electrical Data

Connection Diagrams

Connecting Power, Wiring, and Piping

Installing Interconnecting Piping

Steps for running and connecting refrigerant piping to the indoor unit.

Flare Nut Spacing and Torque

Specifications for flare nut spacing and tightening torque for pipe connections.

Final Tubing Check

Drain Connections

Start-Up Procedure

Test Operation

Procedure for conducting a test operation and verifying functionality.

System Checks

Final Indoor Unit Checks

Troubleshooting

Indoor Unit Diagnostic Codes

Guide to interpreting LED status codes for identifying unit errors.