1.0
Web guiding system EKR 1500 EDV-No.: V3D.010.01.03 Chapter: 1.0
with analogue sensors and CCD 2004 Date: 12.04.2011 Page: 5/5
1.6 Safety instructions
* Installation of the BST eltromat equipment into the production machine according to the relevant
rules ( EN 294, EN 349) and the specific branch-oriented regulations for prevention of accidents,
such as:
- Safety distance between BST eltromat equipment and customer´s specification, e. g. machine
walls, construction etc.
- Installation of connecting cables between amplifier and controller and/or edge sensor
stumble-free, nontension and well anchored.
- Take care of free headroom. If the free passage is limited, respective building components
have to be stuffed and painted in yellow/black.
Assembly, installation and commissioning must be carried out by qualified personnel !
Please do not open the unit until the line voltage is switched off!
When operation at open unit is necessary, only protection class IP20 is present. There
will be an increased risk of danger by line voltage !
- Please do not use the guiding frame as a tread or a step ladder.
- Don’t remove any safety devices.
During functional testing outside of production machine and/or during the start-up
procedure the actuator will carry-out positioning movements!
Make relevant safety arrangements during performance check !
During start-up procedure, the total safety concept of the production machine will have to
be considered.
* Before commissioning remove transport safety devices (if present).
1.7 Emissions
The A-rated equivalent continuous sound level of the equipment is lower than 70 dB(A).
To Next Page
Loading...
Need help?
General