Synergy 3100 user guide ~ 5th Edition ~ 26th September ’02 ~ 4457
12
5 Connect the telephone line cord
Battery performance
Under no circumstances should
non-rechargeable batteries be used.
Only use the approved batteries, type:
rechargeable Nickel Metal Hydride
(Ni-MH); size AAA; capacity
550mAh 1.2v. Using unapproved
batteries will invalidate your guarantee
and may damage the telephone.
To keep your batteries in the best
condition, leave the handset off the
base station for a few hours at a time.
(after the intial 16 hour charge).
Please note, however, that new Nickel
Metal Hydride (Ni-MH) batteries
do not reach their full capacity until
they have been in normal use for
several days.
Fully discharging the batteries at
least once a week will help them last
as long as possible. However, the charge
capacity of rechargeable batteries will
reduce with time as they wear out,
so reducing the talk/standby time
of the handset. Eventually they will
need to be replaced. New batteries
can be obtained from the BT Synergy
Helpline 08706 058 047.
Note: Under ideal conditions, the
handset batteries should give about
14 hours talktime or 350 hours
standby on a single charge. Optimum
times for talk and standby are only
achieved when the handset batteries
are fully charged.
Note
It is recommended that you do not
connect the telephone line cord to the
phone socket until your handset is
fully charged. This will prevent the
risk of the batteries discharging
during a conversation, which could
cause you to lose a call.
SETTING UP
4 Connect the telephone line
cord to the Synergy 3100
base station
To Next Page
Loading...
Need help?
General
