BT 3500 - Setting up the phone; Plan the location; Plug the power supply cord into the back of the base unit

Quartet 3500 User Guide ~ 5th Edition ~ 17th January ’03 ~ 4393
10
Setting up
Follow these steps to set up your Quartet 3500 ready for use.
Plan the location
Situate your Quartet 3500 close enough
to the mains power socket and telephone
socket so that the cables will reach.
Make sure it is at least 1 metre away
from other electrical products to avoid
interference.
Do not situate the product in the
bathroom or other humid areas.
Your Quartet 3500 works by sending
and receiving radio signals between the
base unit and the handset.
The strength of the signal depends on
where you site the base unit and how
the aerials are deployed.
The higher the base unit is located,
the better. An upstairs room is ideal.
2 Plug the power supply
cord into the back of the
base unit
1 Handset and base aerials
Your Quartet 3500 handset and base
use compact aerials which we
recommend you pull out to obtain the
best signal and reception available.
J
K
L
A
B
C
D
E
F
Menu
Power
supply
unit
Telephone line cord
Note
Avoid touching the aerials during a
call as this may cause a clicking sound.