If wall mounting your Caller
Display 1500, use this guide for
position.
• Make sure that you are not
drilling into any hidden wiring.
• Drill two holes 25mm deep
using a 3mm drill, 94mm
apart to take the wall plugs.
• Put wall plugs into the drill
holes and then insert both
screws. Leave 2-3mm
between the head of the
screw and the wall.
• You are now able to mount
the Caller Display 1500 to
the wall.
• Fit the Caller Display 1500
onto the two screws by
1 pushing on and 2 dropping
down. If necessary, tighten
or loosen the screws for the
best fit.
• The whole button panel can
be pushed back into an
upright position if required,
the panel will click into
position.
• The line cord must be
inserted into the cord
channel at the rear of the
Caller Display 1500.
• Ensure the legs at the rear
are secure in the recesses.
1
2
To Next Page
Loading...
