BT PARAGON 650 - Dial Mode; Store an Access Code (Auto Prefix)

If connected to a switchboard, you
may need to enter an access code (e.g.
9) before each number is dialled. Your
BT Paragon 650 can store an access
code which is automatically dialled
before each number.
If set to ON, Auto prefix will only apply
to numbers stored in your phonebook.
Any numbers dialled manually will not
be auto prefixed; this is because
internal numbers are unlikely to need
the prefix.
44
If you experience any problems, please call the Helpline on 0800 218 2182* or email bt.helpdesk@vtecheurope.com
Dial mode
1. Press Menu, scroll to SETTINGS and press OK.
2. Scroll to
DIAL MODE . Press OK.
3. Press or to select the setting you want.
4. Press
Save to confirm.
PBX/switchboard access (Auto prefix)
Store an access code
1. Press Menu, scroll to SETTINGS and press OK.
2. Scroll to
AUTO PREFIX and press OK.
3. Use and to select
ON or OFF . If you select ON follow
steps 4 and 5. If you select
OFF you will go back one level.
4. Enter the access code, e.g. 9.
5. Press
Save to confirm.
Settings
You can set the dialling mode as
Tone/Timed Break, /Tone/Earth or
Pulse/Earth.
Tone is the default setting for the UK
you should only have to change this if
connected to a switchboard that
requires Pulse dialling.