8
If you experience any problems, please call the Helpline on Freephone 0800 218 2182* or visit www.bt.com/producthelp
BT Xenon 1500 multiple pack owners only
Location
You need to place your BT Xenon 1500 charger close enough to a
mains power socket so that the cable will reach.
Setting up the charger
1. Plug the power adaptor cable (item code 048610) into the
underside of the charger and secure the cable behind the
retaining clip.
Plug the other end into the mains wall socket and switch the
power on.
2. Remove the protective film from the handset screen and
activate the batteries by pulling the plastic tab away from the
back of the handset.
3. Place the handset on the charger and charge for at least
24 hours.
Your BT Xenon 1500 multiple pack is now ready
for use.
Mains power cable
To Next Page
Loading...
Need help?
General
