4 Putting into Operation
4 Putting into Operation
The danger zone around the Rotavapor R-220 can extend
outward by up to 10 m. When working inside this danger
zone, there is a risk of damaging the glass parts, which could
cause them to implode.
The electrical connection must be installed and checked by
an authorized person.
4.1 Installation Location
Always set the unit up on a clean, stable, and flat surface.
Never at a location where there is a great deal of personal
traffic (breaking or broken glass)!
A check must always be made to ensure that the explosion-
protection classification of the device is permissible for the
EX-classification of the room. In particular, the zone allocation
and the temperature class must agree.
The dimensions of the rotary evaporator incl. glass are:
Height:
without trolley Reflux 1700 mm
Descending 1800 mm
Bullfrog Reflux 1430 mm
Bullfrog Descending 1550 mm
with trolley Reflux 2300 mm
Descending 2400 mm
Width:
Reflux 1100 mm
Descending 1200 mm
Descending with 2 coolers 1200 mm
Depth:
Single receiver 700 mm
Interchangeable receivers 700 mm
4.2 Unpacking
Take care not to break the glass when opening cartons that
contain glassware.
Look for any damage after unpacking. It is important that
any damage in transit be identified right when unpacking. If
nec essary, make an immediate assessment of the situation
(Notify the post office, the railroad, or the shipping company
involved).
Save the original packing for possible transport at a later date.
Fig. 4.1: Dimensions
1364
656
987
To Next Page
Loading...
