Always ensure that the tester and test piece is securely earthed because this will
reduce any
interference
generated by the spark. This also prevents static build-
up in the operator and thereby avoiding electric shock.
Wherever you are intending to use equipment of this type, on
your site or on a customer’s, always obtain clearance from
the company safety officer.
Maintenance
The PST-100 has been designed to be maintenance free, however the PST-100
should be inspected regularly, checking for damage to the unit. If any
damage is found, the PST-100 must not be used, and should be returned to
the manufacturer for repair.
Two 500mA anti-surge fuses are located on the rear panel. These may be
replaced by the user. Disconnect the PST-100 from the mains supply before
attempting to replace fuses.
Disposal information
Producer registration number: WEE/HJ0051TQ
This product must be disposed of in accordance with UK WEEE
regulations.
For further information on UK WEEE regulations click on:
www.gov.uk/government/publications/weee-regulations-2013-government-
guidance-notes
IMPORTANT: Service and repair of this product and its
components MUST ONLY be undertaken by trained, approved
technicians working in full accordance with Buckleys’ service
guidelines. Failure to do so may expose the operator to
potentially lethal voltages.
Under no circumstances should anyone other than trained
approved technicians attempt to dismantle or repair this
product.
To Next Page
