Bucktool SCM8080 - Page 13

13
Fig. 5Fig. 2
Fig. 3
Fig. 6
Figure 9
Water Reservoir
The wet sharpener is designed for
wet grinding and should never be
used without water.
The mounting tabs on the reservoir
serve as hooks to attach to the
reservoir mounting slots.
to just below the V-shaped notch.
• Attach the reservoir to the sharpener.
-If the sharpener is not going to be used
immediately, do not put the grinding wheel
in water
NOTE
Remove the reservoir to reduce the likelihood
damage to the wheel and potential hazards from being stored in water.
CAUTION
Always lock the switch “OFF” when the sharpener is not in use.
SCM8080
OPERATING INSTRUCTIONS