Electrical Requirement
WARNING: ELECTRICAL REQUIREMENT - SHOCK HAZARD
Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with proper grounding
to power the Beverage Center.
Avoid the use of three prong adapters or cutting o� the third grounding prong in order to
accommodate a two prong outlet. This is a dangerous practice since it provides no e�ective
grounding for the Beverage Center and may result in shock hazard.
•
Use of Extension Cord
Avoid the use of an extension cord because of potential safety hazards under certain
conditions. If it is necessary to use an extension cord, use only a 3-wire extension cord that
has a 3-blade grounding plug and a 3-slot outlet that will accept the plug. The marked rating
of the extension cord must be equal to or greater than the electrical rating of the appliance.
•
•
Installation Limitations
Do not install your Beverage Center in any location not properly insulated or heated (e.g.,
garage etc.). Your Beverage Center was not designed to operate in ambient temperature
settings below 55°F Fahrenheit.
Select a s uitable location for the Beverage Center on a hard even surface away from direct
sunlight or heat source (e.g., radiators, baseboard heaters, cooking appliances, etc.). Any
floor unevenness should be corrected with the leveling legs located on the front and rear
bottom corners of the Beverage Center.
Your Bev e rage Center is designed for freestanding installation only. It is not designed for
built-in application.
Note: This unit is for indoor use only.
•
•
•
To Next Page
Loading...