3
Move packaged unit to approximate position of installation and allow unit to rest upright in the correct position
for 24 hours before plugging in. Failure to comply will void warranty.
NOTES BEFORE INSTALLATION
1. Allow unit to rest upright in the correct position for 24 hours
before plugging in.
2. Position unit in a well ventilated area and ensure you allow a
minimum of 3/4 inches on the sides and 2 inches at the
top and back of the refrigerator.
3. Do not rest any objects on the top or sides of the unit.
4. The refrigerator requires a 110V US type power outlet.
5. After turning the refrigerator on, allow it to reach pre-
programmed temperature (0°C/32°F) over a 12 hour period.
3 LEDs will light up to indicate the correct temperature.
6. After this initial period (minimum 12 hours) the refrigerator
setting can be changed to achieve below zero temperatures
by illuminating all 5 LEDs (-1.5°C/-3.0°C) or (29°F/26°F)
7. To ensure the unit can reach below zero temperatures
efficiently, please load with cold beer as opposed to room
temperature product where possible.
8. It is normal for the sides of the refrigerator to be warm at
times during operation.
To Next Page
Loading...