EasyManua.ls Logo

Budweiser BUD-E - Installing Your Refrigerator (continued); Extension Cord Usage Guidelines; Installation Location Limitations

Budweiser BUD-E
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLING YOUR REFRIGERATOR (continued)
8
Use of Extension Cords
Avoid the use of an extension cord because of potential safety
hazards under certain conditions. If it is necessary to use an
extension cord, use only a 3-wire extension cord that has a
3-blade grounding plug and a 3-slot outlet that will accept the
plug. The marked rating of the extension cord must be equal
to or greater than the electrical rating of the appliance.
Installation Limitations
Do not install your refrigerator in any location not properly
insulated or heated, e.g. garage, etc. Your refrigerator was
not designed to operate in temperature settings below 55˚
Fahrenheit / 12˚ Celsius.
Select a suitable location for the refrigerator on a hard
even surface away from direct sunlight or heat source, e.g.
radiators, baseboard heaters, cooking appliances, etc.
Any floor unevenness should be corrected with the levelling
legs located on the front bottom corners of the refrigerator.
In addition to the sounds from the amplified speaker, normal
operating sounds you may hear:
Boiling water, gurgling sounds or slight vibrations are the
result of the refrigerant circulating through the cooling coils.
The thermostat control will click when it cycles on and off.