Need help?Do you have a question about the Buehler ISOMET Low Speed Saw and is the answer not in the manual?
Guidance on selecting a suitable bench-top placement for the ISOMET™.
Information on connecting the ISOMET™ to the appropriate electrical power source.
Steps for properly loading the specimen and balancing the support arm.
How to adjust the cut-off switch for precise stopping of the saw.
Guidance on adjusting the micrometer and selecting appropriate weights for cutting.
Detailed procedure for setting speed, using the blade wiper, and starting the cutting process.
Procedure for replacing the motor or drive belt, including panel removal steps.
Steps for cleaning and adjusting the micrometer screw assembly.
Procedure for replacing or exchanging the micrometer assembly on the ISOMET™.
Key technical specifications for the ISOMET™ Low Speed Saw, including sound level.
Considerations for using the ISOMET™ in special environments like hot cells or glove boxes.
Various chucks (Swivel Arm, Double, Vacuum, Standard) and flanges for specimen holding.
Dressing Sticks, Dressing Chuck, Splash Guard, and Guide Plates for blade maintenance and specimen handling.
Goniometer for precise sectioning and Chuck Padding for fragile samples.
Specialized cutting fluid for enhanced performance with various materials.
Table detailing Diamond Wafering Blades by series, type, and dimensions for various materials.
General| Blade Speed | 0-300 RPM |
|---|---|
| Cutting Capacity | Up to 2 inches (50 mm) |
| Maximum Blade Size | 5 in. (127 mm) |
| Blade Diameter | 3-5 inches (76-127 mm) |
| Voltage | 50/60 Hz |
To Next Page
