Buffalo Tools MEG300 - Assembly; Assembly Steps

MEG300 Electric Meat Grinder Assembly & Operating Instructions
6
ASSEMBLY
Do not plug this unit into a power source until assembly is complete.
Figure 1
1. Unit should be unplugged while assembling. (Figure 1)
2. Insert Hopper into Attachment Opening and twist upward until it
snaps into place. (Figure 2)
3. Tighten Release Knob. (Figure 3, E)
4. Use Food Stuffer when pressing meat into hopper. (Figure 4)
Cut food into pieces (sinewless, boneless and fatless
meat is recommended, approx 3/4 x 3/4 x 2 inches) so
they fit easily into the hopper. Place a bowl or plate beneath the
grinding tube to catch the ground meat. Note: The grinder must
be ON BEFORE adding food. The grinder head may rotate
slightly during use, but it is normal.
Attachment Opening
Figure 2
Figure 3
E
Figure 4