Buffalo DW467 - Page 12

PROBLEM
CAUSE
SOLUTION
The finish washing
result is inadequate
The suction of the liquid detergent-
rinse aid doesn’t take place
according to the recommendation
of the manufacturer
Check both the peristaltic
pumps and regulate them
according the
recommendation of the
manufacturer of the
machine and the
manufacturer of the
detergent-rinse aid
The hardness of the water is
higher than 9 degree clark
Communicate with your
water provider to learn
about the hardness of the
water of your area. A
water softener may be
fitted
There is too much foam
The machine isn’t warming
sufficiently
Check if the warming
indication has gone out or
is still on
Foaming detergent been used
always use non-foaming
detergent for ware
washing machines
There is incorrect regulations to
the peristaltic pumps
Regulate them according
the recommendation of
the manufacturer of the
machine and the
manufacturer of the
detergent-rinse aid