WHR-1166D Router settings (For PCCW netvigator, HGC broadband PPPoE user)
WHR-1166D PPPoE setup guide 1
Windows user can follow the Preparation for Buffalo Router
Setup Guideline first.
http://support.hornington.com/kb/question.php?ID=616
Hardware Setup of WHR-1166D Router:
1. Set Router switch to “ROUTER”。
2. Power on Buffalo Router and wait for 2 minutes. All LEDs will be lighting
on.
3. To reset the router, please insert “Reset” hole by a paper clip for about
10 seconds, and wait for 2 minute. All LEDs will be lighting on again.
4. Please connect your broadband service with a network cable (or from
cable modem) to the “Internet” port on the ROUTER. Then use another
network cable to connect “LAN1” port on the ROUTER to the Ethernet
adapter on your PC.