adjusting the handlebar
You can adjust the length of the handlebar.
step 6 adjusting the length of the handlebar
a Turn both wing nuts on the outside of the handlebar
anticlockwise.
b This loosens the handlebar. Adjust it to the correct height.
c. Turn both wing nuts clockwise to secure the handlebar.
WARNINGS
• Check that the handlebar is properly fastened.
• The wing nuts must be in the locked position when the handlebar is flipped to the
reverse side to ensure the handlebar securely locks into place.
frame
The frame is fastened to the chassis; the chassis is then secured. The carrycot or seatfabric is
attached to the frame. The frame has 2 frame supports, which ‘click’ onto the 2 frame
bearers. The round side of the frame is always the head end of the carrycot or seat.
step 7 fitting the frame on the chassis
a Completely fold out the 2 frame supports.
To Next Page
Loading...
