16 17Quick Start GuideBugera PS1
(CN) 第二步: 控制
(1) SOAK 控制旋钮调节应
用到音箱输出端的衰减
电平。
注意: 即使 SOAK 控制旋钮
调大到 100 （完全顺时针）,
音箱的有效功率也大约为
功放输出功率的一半。
(2) LINE 控制旋钮调节 LINE
输出接口的信号电平。
(3) EMULATED MIC 平衡式 XLR
输出端模拟音箱前面的
一个话筒, 非常适合馈入
信号到 PA / 录音调音台。
(4) LINE 输出接口用于在专业
应用中连接外部功放或
效果器。 LINE 输出端的信
号不通过音箱 / 话筒模
拟处理。
(5) SPEAKER 输出接口可连接
音箱。 请使用音箱线连接！
(6) AMP INPUT 接口提供 4, 8
或 16 Ohms 的阻抗来匹配
任何功放。 请使用音箱
线连接！
Bugera PS1 Controls Bugera PS1 Getting startedBugera PS1 Getting started
(EN) Step 3: Getting
started
Power on your tube amp,
and switch the amp into
Standby mode while
making connections.
Choose an appropriate Ohm
rating to match both the
amplifier’s Ohm setting and
the speaker cabinets Ohm
rating. For example, if the speaker cabinet
is rated at 4 Ohms, make sure to use the “4
Ω” AMP INPUT jack, and make sure your
amplifier is also set to run at 4 Ohms.
Run a speaker cable from
the amplifier’s speaker
output to the AMP INPUT
jacks on the back of the PS1.
ATTENTION! To avoid
damage to your amp,
never use a valve
amplifier without a
load connected, such as PS1 and/or
a loudspeaker!
Run another speaker cable
from the SPEAKER output
jack to the speaker cabinet’s
input.
Always use loudspeaker
cables for connection
between the amplifier
and the loudspeaker.
Never use other types of cable such
as instrument cable and microphone
cable.
Run an XLR cable from the
EMULATED MIC output to
your mixing board channel
inputs if you wish to record
or perform with a buffered direct signal
rather than using a microphone.
Run a standard line-level ¼"
TS cable from the LINE
output to additional
amplifier’s or other
outboard gear for further processing. The
signal from the LINE output is not treated
with speaker/mic simulation.
For minimal volume, set the
SOAK and LINE knobs to 0
(full counter-clockwise).
Connect your guitar to the
amp input, and then switch
the amp from Standby mode
to ON.
While playing, turn amp
volume and SOAK up slowly,
until you find a good balance
between volume and the
tonal characteristics of your amp.
NOTE: Even with the SOAK control turned
up to 100 (full clockwise) the effective
power at the speaker will be about half of
the amplifier output power.
If you are running a signal
from the LINE output, turn
the LINE knob clockwise
until you find the correct
gain for your additional
outboard equipment.
To Next Page
Loading...