CHECKOR SERVICE
I
WHAT
TO
DO
Underbody At least every spring, use plain water
to
Flushing flush any corrosive materials from the
underbody. Take care
to
clean
thoroughly any areas where mud and
other debris can collect.
Section
C:
Periodic Maintenance
Inspections
Listed below are inspections and services which should
be performed
at
least twice a year (for instance, each
spring and fall).
You
should let your
GM
dealer’s
service department or other qualified service center do
these jobs. Make sure any necessary repairs are
completed at once.
.
INSPECTION
OR
SERVICE
Restraint Systems
Steering,
Suspension and
Front-Wheel-
Drive Axle Boot
md Seal
Inspection
WHAT SHQULD
BE
DONE
Now and then, make sure all your belts,
buckles, latch plates, retractors,
anchorages and reminder systems are
working properly. Look for any loose
parts or damage. If you see anything
that might keep a restraint system from
doing its jobs, have
it
repaired
Inspect the front and rear suspension
and steering system for damaged, loose
or missing parts, signs of wear, or lack
of lubrication. Inspect the power
steering lines and hoses for proper
hookup, binding, leaks, cracks,
chafing, etc. Clean and then inspect the
drive axle boot seals for damage, tears
or leakage. Replace seals
if
necessary.
277
To Next Page
Loading...
