Universal Transmitter (Option)
This
transmitter allows you to consolidate the functions
of up to three individual hand-held transmitters. It will
operate garage doors and gates, or other devices
controlled by radio frequency such as home/office
lighting systems.
The transmitter will learn and transmit the frequencies
of
most current transmitters and is powered by your
vehicle’s battery and charging system.
This
device complies with
Part
15
of the
FCC
Rules.
Operation is subject to the following two conditions:
(1)
This
device may not cause harmful interference, and
(2)
This
device must accept
any
interference received,
including interference that may cause undesired operation.
This device complies with
RSS-210
of
Industry and
Science Canada. Operation is subject to the following
two conditions:
(1)
this device may not cause
interference, and
(2)
this device
must
accept any
interference, including interference thay may cause
undesired operation of the device.
Changes or modifications to this system by other than an
authorized service facility could void authorization to
use
this
equipment.
Programming the Transmitter
Do
not use the universal transmitter with any garage
door opener that does not have the “stop and reverse”
safety feature. This includes any garage door opener
model manufactured before April
1,
1982.
Be sure that people and objects are clear of the garage
door you are programming.
Your vehicle’s engine should be turned off while
programming your transmitter. Follow these steps to
program up to three channels:
1.
If you have not previously programmed a universal
transmitter channel, proceed to Step
2.
Otherwise,
hold down the two outside buttons on the universal
To Next Page