Headlamp HighlLow Beam
To change the headlamps
from low beam to high or
high to low, pull the turn
signal lever toward you.
Then release it. When the
high beams
are
on,
this light
on the instrument panel will
also be on.
Flash-To-Pass
Featr?
This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass. It
works even if your headlamps
are
off.
To use it,,pull the turn signal lever toward you
a
little,
but not
so
far that you hear a click.
If
your headlamps
are
off or on low beam, your
high-beam headlamps will turn
on.
They’ll stay on
as
long as you hold the lever toward you and the high beam
indicator
on
the dash will come
on.
Release the lever to
turn the high-beam headlamps
off.
Windshield Wipers
You control the windshield wipers by turning the band
marked WIPER DELAY.
For a single wiping cycle, turn the band to MIST. Hold
it
there until the wipers start, then let go. The wipers will
stop after one cycle. If you want more cycles, hold the
band on MIST longer.
You
can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain or
snow. Turn the band to choose the delay time. The
closer to
LO,
the shorter the delay.
2-37
To Next Page