3-10
Defogging and Defrosting
If you have the electronic touch system, press the
FRONT button and adjust the TEMPERATURE lever
toward WARM and the FAN lever toward HIGH.
If you have the Dual Automatic ComforTemp
t
system,
use the FRONT button to defog or defrost the
windshield. By choosing this button, the airflow will be
directed at the windshield. Adjust your temperature
level by pressing the TEMP up or down arrow. The fan
speed will be controlled by the system. You can change
the fan speed by pressing the up FAN arrow to increase
speed, and the down arrow to decrease speed.
To reduce the chance of fogging your windows in cold
weather, using the electronic touch system, select HTR
to supply air through the floor ducts. Then move the
FAN lever to HIGH for a few moments before driving
away. This will blow moist air from the intake outlets
toward the floor, not the windshield. If you have the
Dual Automatic ComforTemp system, the AUTO setting
will do this for you. Manual operation of the automatic
ComforTemp system in the floor mode will also supply
air through the floor ducts.
Rear Window Defogger
The lines you see on the
rear window warm the
glass. Press this button to
start warming your rear
and side windows.
At speeds above 35 mph (55 km/h), the defogger
will operate continuously until you press the REAR
button again. After 10 minutes of driving below 35 mph
(55 km/h), the defogger will turn off automatically. If
you need additional warming time, push the button
again. The system will then operate for five minutes
before going off by itself.
To Next Page
Loading...
Need help?
General
