1-3
Power Seats (If Equipped)
If your vehicle has this feature, the power seat controls are
located on the outboard side of each front seat cushion.
D
Raise or lower the front of the seat cushion by holding
the front part of the horizontal control up or down.
D
Raise or lower the rear of the seat cushion by holding
the rear part of the horizontal control up or down.
D
Raise or lower the entire seat cushion by holding the
whole horizontal control up or down.
D
Move the seat forward or back by pushing the
horizontal control to the front or back.
D
Push the vertical control forward to bring the
seatback to a more upright position. Push it rearward
to recline the seatback. See “Reclining Front
Seatbacks” later in this section.
Power Lumbar Control (If Equipped)
If your vehicle has this
feature, the power lumbar
control is located on the
outboard side of each front
seat. Use the power seat
control first to get the
proper position. Then
continue with the
lumbar adjustment.
To reshape the lower seatback, press the lumbar control
forward to increase support and rearward to decrease
support. Press the control up or down to raise or lower
the support mechanism.
Keep in mind that as your seating position changes, as it
may during long trips, so should the position of your
lumbar support. Adjust the seat as needed.
To Next Page
Loading...
Need help?
General
