Heated Seats (if equipped): The buttons
to control this feature are located on the
front door armrests. Controls can be set
to heat the seatback only or the seat-
back and the seat cushion. The three
lights next to the controls indicate LO,
MED or HI setting. Push the vertical
switch (B above) to activate heat for the
seatback only. An indicator light illumi-
nates when the seatback is being heat-
ed. Push the horizontal switch
(A above) to heat the whole seat.
See Section 1 of your Owner Manual.
Easy Exit Driver Seat
Two personalized driver exit seat posi-
tions can be set by following these
steps:
1. First, set the Easy Exit Driver Seat
feature to ON in your Driver
Information Center (see “Vehicle
Personalization” in the Driver
Information Center section of this
booklet).
Getting to Know Your Rainier
10
Seats
A
B
Electric Adjustable Pedals
(if equipped)
Drivers can adjust
the brake and accel-
erator pedals to a
comfortable position
by using the toggle
switch located on the steering column.
The vehicle must be in Park (P) for this
feature to operate.
• Press the switch toward you to move
the pedals closer.
• Press the switch away from you to
move the pedals farther away.
This feature can be programmed to work
with your vehicle’s memory feature. See
the Memory Settings for Driver’s Seat,
Mirrors and Pedals section of this
booklet.
See Section 2 of your Owner Manual.
Note: The engine must be running for
the heated seat feature to operate.
Ranier06 Beta5.qxd 5/31/05 10:36 AM Page 10
To Next Page
Loading...
Need help?
General
