After the tires have been rotated, adjust the
front and rear inflation pressures as shown on
the Tire and Loading Information label.
See Inflation - Tire Pressure on page 5-70
and Loading Your Vehicle on page 4-21.
Reset the Tire Pressure Monitor System.
See Tire Pressure Monitor Operation on
page 5-73.
Make certain that all wheel nuts are properly
tightened. See “Wheel Nut Torque” under
Capacities and Specifications on page 5-114.
{CAUTION:
Rust or dirt on a wheel, or on the parts to
which it is fastened, can make wheel nuts
become loose after time. The wheel could
come off and cause an accident. When
you change a wheel, remove any rust or
dirt from places where the wheel attaches
to the vehicle. In an emergency, you can
use a cloth or a paper towel to do this;
but be sure to use a scraper or wire brush
later, if needed, to get all the rust or dirt
off. See Changing a Flat Tire on page 5-86.
5-77
To Next Page
Loading...
Need help?
General
