Vehicle Care 10-5
3. Lift the hood and pull the prop
rod by the sleeve from the
retainer, located above the
radiator.
4. Securely place the hood prop
into the slot on the underside of
the hood.
To close the hood:
1. Before closing the hood, be sure
all the filler caps are on properly.
Then, lift the hood to relieve
pressure on the hood prop.
Remove the hood prop by the
sleeve from the retainer slot on
the underside of the hood and
return the prop to its retainer
located above the radiator. The
prop rod must click into place
when returning it to the retainer
to prevent hood damage.
2. Lower the hood 20 cm (8 in)
above the vehicle and release it
so it fully latches. Check to
make sure the hood is closed
and repeat the process if
necessary.
To Next Page
Loading...
Need help?
General
