Buick 2015 Verano - License Plate Lamp

Black plate (29,1)
Buick Verano Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
7707488) - 2015 - CRC - 5/28/14
Vehicle Care 10-29
4. For the passenger side bulb,
remove the pull handle
fasteners (2) and pull handle.
5. Pull the trunk deck trim down far
enough to gain access to the
lamps.
6. Remove the bulb socket by
turning counterclockwise.
7. Remove the bulb from the
socket by pulling straight out.
8. Install the new bulb in the bulb
socket.
9. Reverse Steps 1–7 to reinstall.
Stoplamp, Taillamp, and Turn
Signal Lamp
Driver Side Shown, Passenger
Side Similar
1. Taillamp
2. Turn Signal Lamp
3. Stoplamp/Taillamp
To replace any one of these bulbs:
1. Open the trunk.
2. Remove the push pins securing
the trunk trim.
3. Pull the trunk lining away from
the taillamp assembly.
4. Turn the bulb socket
counterclockwise to remove it
from the rear taillamp assembly.
5. Pull the bulb straight out to
remove it from the bulb socket.
6. Push the new bulb into the
socket.
7. Push the bulb socket straight in
and turn it clockwise to lock it
into place.
8. Reinstall the trunk trim.
9. Reinstall the push pins.
License Plate Lamp
Lamp Assembly
Bulb Assembly