Buick 2016 Regal - Jump Starting; Jump Starting - North America; Eassist Only)

Buick Regal Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-
9159380) - 2016 - crc - 6/8/15
290 Vehicle Care
Jump Starting
Jump Starting - North
America (On-board with
eAssist Only)
If the vehicle fails to crank, it may
be jump started by using the eAssist
battery to charge the 12-volt battery.
Use the following procedure to
activate the on-board jump start
using the DIC controls.
DIC Buttons
The vehicle may be equipped with
an ignition key or an electronic
keyless ignition with pushbutton
start.
Key Access
Place the ignition key in the ON/
RUN position and proceed as
follows:
1. Press
S then scroll y or z
until the Settings menu
displays.
2. Press
V to enter the
Settings menu.
3. Press
T then scroll y or z
until Jump Start displays.
4. Press
V to activate the jump
start.
5. The system will then ask for
confirmation. If Yes is selected,
the jump start will begin and
the display will show JUMP
START ACTIVE WAIT TO
START.
6. When the jump start is
complete, the display will show
JUMP START COMPLETE
ATTEMPT START or JUMP
START DISABLED SEE
OWNERS MANUAL.
Keyless Access
With the brake pedal not applied,
press and hold the ENGINE START/
STOP button for more than
five seconds. This will place the
vehicle in the Service Only Mode.
Proceed as follows:
1. Press
S then scroll y or z
until the Settings menu
displays.
2. Press
V to enter the
Settings menu.
3. Press
T then scroll y or z
until Jump Start displays.
4. Press
V to activate the jump
start.
5. The system will then ask for
confirmation. If Yes is selected,
the jump start will begin and
the display will show JUMP
START ACTIVE WAIT TO
START.
6. When the jump start is
complete, the display will show
JUMP START COMPLETE