Buick Cascada 2016 - Page 19

19
Convertible Top Wind Deflectors
The wind deectors are located in a bag
behind the rear seatbacks. The small
wind deector ts between the rear head
restraints. The large wind deector installs
behind the front seats.
Small Wind Deector Installation
1. Lower the rear seatbacks.
2. Slide the cover between the rear head
restraints toward the driver’s side of
the vehicle to remove it.
3. Insert the small wind deector (A) into
the channel and slide it toward the pas
-
senger’s side of the vehicle until it locks.
4. Raise the rear seatbacks.
Large Wind Deector Installation
Note: The rear seat cannot be occupied with the
large wind deector installed.
1. On each corner of the wind deector,
turn out the upper locking pins (B) and
lift the detents to release the lower
locking pins (C).
2. Open the wind deector.
3. Insert the pins into the side recesses (D)
on the passenger’s side of the vehicle.
4. Slightly fold the deector and insert
the pins into the side recesses on the
driver’s side of the vehicle.
5. Push down the center of the deector
to fully engage the pins.
6. Fold the deector to the vertical
position.
Stowing the Wind Deectors
Stow the wind deectors in the stowage
bag when not in use. Place the bag behind
the rear seatbacks and secure the bag with
the straps.
See Keys, Doors and Windows in your Owner Manual.
C
B
C
A
D
D
B