3-20 Seats and Restraints
To install:
1. Locate the anchor loop (1) on
the rear outboard seatback.
2. Attach the adjustable comfort
guide (2) to the anchor loop by
threading the hook through
the loop.
3. Place the guide over the belt,
and insert the two edges of the
belt into the slots of the guide.
4. Be sure that the belt is not
twisted and it lies flat. The
elastic cord must be behind the
belt with the plastic guide on the
front.
5. The elastic cord on the comfort
guide is adjustable. Make it
longer or shorter by squeezing
both ends of the plastic adjuster
and pulling on the elastic cord or
the guide.
To Next Page
Loading...
