3-12 Seats and Restraints
7. Fold the seatback forward
and down.
Safety Belt Clip on Side Trim
8. Place the outboard safety belt in
the safety belt clip (if equipped)
on the side trim of the vehicle.
9. Repeat Steps 1–8 for the other
seatback and seat cushion,
if desired.
Raising the Seatback
{
WARNING
If either seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always push and pull on the
seatbacks to be sure they are
locked.
{
WARNING
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. After raising the
rear seatback, always check to be
sure that the safety belts are
properly routed and attached, and
are not twisted.
To Next Page
Loading...
