16
F
Optional equipment
CRUISE CONTROL
Setting Cruise Control
1. Press the
On/Off button. The
Cruise Control symbol will illuminate in white on the
instrument cluster.
2. When traveling at the desired speed, press the switch down to the SET- position to set
the speed. The
symbol will illuminate in green on the instrument cluster.
Adjusting Cruise Control
RES+ Resume/Accelerate
Press up to resume a set speed. When the
system is active, press up to increase speed.
SET– Set/Coast
When the system is active, press down to
decrease speed.
Cancel
Press to cancel the cruise control without erasing the set speed from memory. Pressing the
brake pedal will also cancel the cruise control.
The set speed is erased when cruise control or the vehicle ignition is turnedoff.
Adaptive Cruise Control
F
The system maintains the cruise control set speed and the following gap — the time between
your vehicle and a vehicle detected directly ahead — by accelerating or braking.
Following Gap
Press to select a following gap setting of Far, Medium, or Near. This is also the Forward
Collision Alert setting.
See Driving and Operating in your Owner’s Manual.
AUTOMATIC TRANSMISSION
Driver Shi Control
Driver Shi Control is a manual mode that
allows the driver to shi gears manually. This
feature can be used to limit the top gear and
vehicle speed or to downshi when driving on
a downhill grade to provide engine braking.
1. Move the shi lever le to the L (Low)
position.
2. Press the + (plus) or – (minus) button on
the shi lever to upshi or downshi. The
current gear will be displayed on the Driver Information Center.
If vehicle speed is too high or too low for the requested gear, the shi will not occur.
See Driving and Operating in your Owner’s Manual.
To Next Page
Loading...
