Buick ENVISION 2019 - Remote Keyless Entry Transmitter; Remote Lock and Unlock Functions; Power Liftgate Operation; Vehicle Locator and Panic Alarm

4
REMOTE KEYLESS ENTRY (RKE) TRANSMITTER
KEYLESS ACCESS SYSTEM
Lock
Press to lock all doors.
Unlock
Press to unlock the driv-
er’s door. Press again
to unlock all doors.
Power Ligate
Press twice to open or close the ligate.
Press once to stop power ligate operation.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle.
The exterior lamps will ash and the horn
will sound.
Press and hold to activate the alarm. Press
it again to cancel the alarm.
Note: To change the remote lock, unlock, and
remote start settings, go to Settings > Vehicle >
Remote Lock, Unlock, Start.
Remote Vehicle Start
Press and release the Lock button and
then immediately press and hold the
button until the turn signal lamps ash to start
the engine from outside the vehicle. Aer
entering the vehicle, turn on the ignition.
• During a remote start, the engine will run
for 10 minutes. Repeat these steps to run
the engine for an additional 10 minutes.
A remote start can be extended once.
• Press and hold the button until
the parking lamps turn off to cancel a
remote start.
Remote Start and Heated Seats: Select
the remote start heated seat option in the
Vehicle Settings to have the heated seats
turn on during a remote start. The heated
seat button indicators do not illuminate and
the temperature of the unoccupied seat may
be reduced during a remote start.
The Keyless Access System enables operation of the
doors, ignition and ligate without removing the Remote
Keyless Entry transmitter from your pocket or purse. The
transmitter must be within 3 feet of the door or the
ligate for the system to operate.
Keyless Unlocking
With the transmitter within range:
Press the lock button on the driver’s door handle to unlock the driver’s door; press it
again within 5 seconds to unlock all doors.
Press the lock button on a passenger door handle to unlock all doors.
Press the touchpad on the ligate handle to open the ligate.
Keyless Locking
With the ignition off, the transmitter removed from the vehicle, and all doors closed:
Press the lock button on any door handle to lock all doors immediately.
If Passive Locking is turned on, all doors will lock automatically aer a short delay.
Note: To change the keyless locking and unlocking settings, go to Settings > Vehicle > Remote Lock,
Unlock, Start.
See Keys, Doors and Windows in your Owner’s Manual.
See Keys, Doors and Windows in your Owner’s Manual.