15
HomeLink
®
Universal
Transmitter
This programmable transmitter can store
three frequencies for items such as a
garage door opener, entry door lock or
security system. With the ignition OFF,
program the transmitter as follows:
• Press and hold the two outside but-
tons and release when the indicator
light begins to flash (about 20 sec-
onds; do not repeat this step when
programming second and third trans-
mitter buttons).
• Hold the end of your hand-held trans-
mitter up to three inches away from
the surface of the universal transmit-
ter and simultaneously hold down
the transmitter button and the button
on the HomeLink
®
unit you wish to
program.
• The HomeLink
®
indicator light will
begin blinking slowly. Programming is
complete when the red light on the
HomeLink
®
transmitter flashes rapidly.
• Release both buttons.
• Press and hold the newly pro-
grammed HomeLink
®
button. If the
light stays on constantly, program-
ming is complete and should operate
your device when pressed and
released.
For garage door openers with a “rolling
code,” continue with the following steps:
• Firmly press the training button (usu-
ally marked “LEARN” or “SMART”) on
the garage door opener motor head
unit near the antenna.
• Within 30 seconds, press and hold
the HomeLink
®
transmitter button pro-
grammed in the previous steps for
two seconds.
• Press and release this button twice
more for two seconds each time.
See Section 2 of your Owner Manual.
Remote Keyless Entry System
The RKE system locks and unlocks the
doors and lift glass from a range of 3 to
30 feet (1–9m). At times the range may
be shorter than usual, which is normal. If
the transmitter doesn’t seem to be work-
ing properly:
• Ensure that you are within transmitter
range of the vehicle. Rainy and
snowy weather can reduce transmit-
ter range.
Note: To ensure successful HomeLink
®
Transmitter programming, it’s important
that your garage door opener battery be
well charged.
Rainier2004r7a 7/23/03 3:37 PM Page 15
To Next Page
Loading...
