Bull 30008 - User Manual

Questions and Answers

H
heather13Jul 27, 2025
What to do if my Bull 30008 Burner won't stay lit?
- J
  Jeffery BenjaminJul 27, 2025
  If your Bull Burner won't stay lit, consider these potential causes: * A misaligned burner tube; reposition the burner tube to properly seat inside the venturi tube. * An obstruction in the gas line; remove the fuel line and briefly open the gas supply to clear any blockage, then reconnect the fuel line. * A plugged orifice; remove the orifice and gently clear any obstruction with a fine wire, then reinstall it. * Misalignment of the igniter on the burner; check the igniter tip's position, ensuring it's close to the burner ports and free of grease. Also, verify the ignition wire is firmly connected. If these steps do not work, turn off the gas, set the control knob to 'OFF', and wait five minutes before retrying.
U
unguyenAug 6, 2025
How to fix a Bull Burner that is not working?
- E
  Elizabeth LawrenceAug 6, 2025
  If your Bull Burner is not working correctly, try the following: * Turn off the gas at the source, turn the control knob to 'OFF', and wait five minutes before trying again. * Ensure the burner tube is correctly aligned inside the venturi tube; reposition if necessary. * Check for obstructions in the gas line; remove the fuel line and briefly open the gas supply to clear any blockage, then reconnect the fuel line. * Clear any blockage in the orifice with a fine wire after removing it from the venturi tube, then reinstall. * Verify the igniter's position and connection; the tip should be close to the burner ports and free of grease, and the ignition wire should be firmly connected.
T
Tyler LyonsAug 16, 2025
Why my Bull 30008 won't ignite?
- M
  Mark FieldsAug 17, 2025
  Several factors can prevent your Bull Burner from igniting: * A misaligned burner tube; reposition the burner tube to properly seat inside the venturi tube. * An obstruction in the gas line; remove the fuel line and briefly open the gas supply to clear any blockage, then reconnect the fuel line. * A plugged orifice; remove the orifice and gently clear any obstruction with a fine wire, then reinstall it. * Misalignment of the igniter on the burner; check the igniter tip's position, ensuring it's close to the burner ports and free of grease. Also, verify the ignition wire is firmly connected. If these steps do not work, turn off the gas, set the control knob to 'OFF', and wait five minutes before retrying.