Bull II Series User Manual (English)

Questions and Answers:

O
oriveraJul 29, 2025
Why is my Bull Refrigerator not cold enough?
- S
  Sandra DominguezJul 30, 2025
  Several factors could be the reason your Bull Refrigerator isn't cooling properly. The temperature setting might be incorrect, or the ambient temperature may require a lower setting. Avoid opening the door too frequently or leaving it ajar. Ensure the door seal is intact and clean, and that the condenser is clean. Also, make sure the ventilation opening isn't blocked or dusty. Adjust the temperature, close the door properly, clean the condenser, and clear any obstructions to resolve this.
B
Barbara MitchellAug 4, 2025
How to fix a Bull II Refrigerator that won't turn on?
- R
  reidmaryAug 4, 2025
  If your Bull Refrigerator isn't turning on, first ensure that the appliance is switched on and properly connected to a power supply. Check your circuit breaker or fuse box, and switch the circuit breaker or replace the fuse if necessary. These steps should help restore power to your refrigerator.
D
Dr. Evelyn BrownAug 10, 2025
Why does my Bull Refrigerator keep turning on and off?
- W
  William ColemanAug 11, 2025
  Your Bull Refrigerator might be turning on and off frequently due to several reasons. The room temperature could be higher than average, or a large amount of food might have been added recently. Make sure to place the appliance in a cooler spot and allow it to reach the set temperature after adding food. Also, avoid opening the door too often and ensure it closes completely. Check the door gasket for proper sealing; clean or replace it if necessary.
M
mitchelllisaAug 16, 2025
What to do if the alarm sounds and the temperature display flashes on my Bull II?
- K
  Kathy RivasAug 16, 2025
  If the alarm sounds and the temperature display flashes on your Bull Refrigerator, it might be because the door has been open for longer than 60 seconds. If this is the case, close the door. Avoid opening the door more often than necessary, clear any obstructions, clean the dust, and allow the appliance to work until it reaches the set temperature.