Bulldog EVC300 Controller
QuickStart Guide
1
MAINTENENCE
Maintenance should be performed every 6 months to
ensure your device is armed and in working order.
Check Leak Sensor Battery
NOTE: Testing a Leak Sensors will trigger a leak alert.
1. Set your leak sensor on a wet paper towel.
2. Listen for the number of beeps.
• (2 beeps): Battery is charged.
• (3 beeps): Battery is low and needs to be replaced.
• (No beeps): Battery is dead, or leak sensor is not
properly being triggered.
• (Beeps but no leak alert): Leak Sensor is unpaired
or non-functional.
(Refer to section: Pairing Leak Sensors &
Optional Emergency Stop Button)
To Next Page
Loading...