Bullet tools Vinyl Glider - Vinyl Glider Blade Management; Blade Change Procedure; Maintenance Recommendations

For easier adjustment, apply grease or teflon spray
(such as Bullet Tools Slick Shot ™) to the slide shafts at the start of every work day.
Clean all glue residues from the runners and blade cartridge
with mineral spirits or similar solvent before storing.
F
K
G
J
H
J
Extend the blade cartridge fully by turning the handle knob clockwise until it
stops. Do not force the knob further.
Use a pen or small screwdriver to push the axle pin Z out of the blade cartridge.
Slide the blade and spacers out of the blade cartridge.
Discard the old blade and place a new one onto the axle pin , sandwiched between
the two spacers.
Apply a film of grease to the small steps on the sides of the spacers and to the axle
pin.
Slide the blade and spacers back into the blade cartridge and center the
axle pin.
G
G
G
G
F
F
K
H
H
J
J
J
J
F
Blade Change
Maintenance
PRT-INS-5201.R1.2.17 ©2017 Bullet Tools