24
NOTE: On initial connection the installer is prompted for
electrical congurations. e Low-Level setting is selected by the
installer. e Phase and Amperage is set automatically. Default
settings should be conrmed by the installer to match the actual
phase and amperage at the spa’s installation location. In rare
occassions it may be necessary to adjust the Phase and Amperage
setting to match the actual service available at the installation
location using the instructions above.
* Depending on pack conguration, a code may be required
to change the low level number, number of phases or input
current. is code is “5555”.
About
is screen displays technical information about the control
system (R800) software on your R Series spa and applicable
revisions of the dierent components of your system.
Audio System Controls (Optional)
Press the
(Mode) or (Audio) button, as applicable to your
spa model, to access “in.stream 2” player controls.
If you are using a device with Bluetooth technology, it must be
connected for functions to work. Use code 5555 to pair.
Note: Play/Pause functions apply only to Bluetooth and USB
source. Change Track or station functions works with all sources
except AUX.
Turning power On/O: Press the Power key to turn the
in.stream 2 on or o.
Selecting the source: Press the Source key to toggle between
available sources.
Play/Pause audio: Press the Play/Pause button to start or pause
the audio.
Adjusting the volume: Press the Volume Up or the Volume
Down key to increase or decrease the volume.
Changing tracks: Use the Last Track and Next Track keys to
change tracks. Note that in FM mode these functions can be used
to change stations.
Disconnect: is option can be found under the Audio section
in the Settings menu.
Fader, Balance and Subwoofer: Fader, Balance and Subwoofer
settings can be edited under the Audio section in the Settings
menu if your in.stream 2 supports it.
e rst time you use your Bluetooth device with the R Series
Audio system you must rst “pair” your device to the spa audio
system according to the standard pairing functionality of your
specic device. Each device must be paired separately.
For proper function, place your Bluetooth device within 20 feet (6
meters) of your spa. e device should have “line of sight” to the
spa control panel / equipment door area.
NOTE: Certain house construction materials and other
obstructions can impair Bluetooth connectivity. You may need to
experiment with where to place your device for best results.
To Next Page
Loading...
